Foul Waste Packaged Pump Station MagnaPro200 Macerator

Installation guidelines

It is important to note that these instructions are for guidance only. Please refer to the full Installation and Operating Guidelines when specifying / installing the products.

Siting the product

The MagnaPro 200 (Macerator) is designed to be installed below ground level and so the prevailing ground conditions must be considered prior to locating the unit. Where possible, installation of a pumping station in a roadway should be avoided due to the need for periodic maintenance of the pump contained therein. If the location is adjacent to a roadway, the installation method should take into account the imposed loads likely to be transmitted to the tank by traffic etc.

The MagnaPro 200 (Macerator) should be positioned in a sump with sufficient dimensions to allow for a concrete surround.

Inlet connection

The MagnaPro 200 (Macerator) comes complete with a 110mm rubber connector located on the side of the tank that will accept 110mm uPVC soil waste pipe. The waste pipe needs to be run with sufficient gradient to allow the waste to gravity drain into the unit and should be pushed firmly into the 110mm rubber connector so as to form a watertight seal around the incoming pipe.

NOTE – Inlets can be positioned to your requirement but must be specified at time of order.

Discharge connection

The connection of the discharge line is via the supplied compression adaptor. This connector is designed to accept black MDPE / MDPE pipework of appropriate outer diameter.

Electrical connection

A qualified person in accordance with the Institute Of Electrical Engineers Regulations should connect the unit to the appropriate mains supply taking into account all the electrical information provided.

IMPORTANT – All pump systems must be used with an appropriate motor rated protection device.

Maintenance

We recommend that the unit be inspected every three months. The inside of the MagnaPro 360 should be inspected to ensure the floats are clean and free of any build up of materials that may inhibit the operation of the float switch. Also the moving parts of the pump should be checked to ensure that they are moving freely. Hose down the interior of the tank if necessary to remove any build up of solid materials and the bottom of the tank should be checked to make sure there is no debris or materials that could enter the pump and cause irreparable damage.
In addition we recommend that a service agreement be taken out with a technically qualified company.

Health & safety

As with all site work, the danger of working with water and electricity can pose a severe threat to health if obvious and fundamental precautions are not taken. Therefore if you are in any doubt regarding the installation, please contact us.

All site work must be undertaken by qualified personnel only.

These notes are for guidance only and it is for the installer to ensure the installation is in accordance with all structural and regulatory requirements.