Newton HydroCoat 105 1K Cementitious Waterproofing Slurry and Mortar
Newton HydroCoat 105 1K is a single-component, polymer-modified, cement-based waterproofing slurry that incorporates advanced micro silica polymer and fibre technology. When cured, it creates a dense matrix with very high adhesion that is impermeable to water to 10 bar of water pressure to both the positive and negative pressure sides of the structure.
HydroCoat 105 1K is supplied as a single-component system, requiring only the addition of clean water to form a mortar, a suitable bag-rubbing mix, a surface repair product, a fairing coat/thin section bonded screed, and a waterproofing render. Add slightly more water or tanking slurry and apply by spray by airless machine.
Newton HydroCoat 105 1K is one product with five uses. Keep a bag on the van at all times.
KEY BENEFITS
- 2 mm slurry coat is fully waterproof and resists 10 bar positive and negative water pressure
- Can be applied to damp substrate
- Can be part-mixed
- Can be applied as a mortar to 6 mm thickness and so can be used to waterproof, smooth and/or repair rough and uneven surfaces in just one application
- Environmentally friendly product that is ideal for confined spaces
- Strong with quick strength gain – 13 MPa within 1 day
- Quick drying times – rain tight within 1 hour
- Odourless and VOC free
- Waterproofing of structural concrete
- Waterproofing of structural masonry
- Waterproof smoothing or fairing coat for rough faced surfaces
- Waterproof surface repair
- Waterproof levelling and repair to floors
- Filling surface pinholes to concrete and smoothing rough-faced block walls using bag rubbing technique
- Concrete
- Structural masonry/mortar
Waterproofing of:
- Walls – Positive pressure and negative pressure
- Slab/raft – Negative pressure
- Soffit – Negative pressure
APPLICATION RATE
HydroCoat 105 1K is applied in one, or two coats depending on the application:
Waterproofing walls & soffits – slurry
- Number of coats = 2
- Thickness of each coat = 1 mm
- Total thickness = 2 mm
- Coverage per coat – mixed slurry = 1.85 kg/m²
- Total coverage = 3.7 kg/m²
- Coverage per 25 kg container = 7.9 m²
Waterproofing floors – slurry
- Number of coats = 1 or 2
- Thickness of each coat = 1 mm or 2 mm
- Total thickness = 2 mm
- Coverage per coat – mixed slurry = 1.85 kg/m² or 3.7 kg/m² if applied in one coat
- Total coverage = 3.7 kg/m²
- Coverage per 25 kg sack = 7.9 m²
Fairing coat & wall surface repair – mortar
- Maximum thickness per layer = 6 mm
- Mixed coverage per mm = 1.85 kg/m²
- Mixed yield per sack = 15.8 litres
Floor surface repair and levelling – mortar
- Maximum thickness per layer = 6 mm
- Coverage per mm = 1.85 kg/m² = 1 litre
- Mixed yield per sack = 15.8 litres
Reviews
There are no reviews yet.