Larsen SLC 2000 Professional Industrial Self Levelling Screed

Larsen SLC 2000 is a professional Industrial is a single pack, fast-drying, hand or pump-applied, cement-based levelling screed for the renovation of concrete floors.

Larsen SLC 2000 is manufactured from a controlled blend of special sands, cements and synthetic polymers to give a high quality flooring product which is self-levelling and smoothing. For use in fast track commercial and industrial situations where a wearing finish is required or when finishes need to be applied quickly. It is ideal for warehouses, production areas and similar areas where a hardwearing level finish is required. SLC 2000 Industrial can be over-coated with epoxy coatings, etc. to further improve abrasion resistance, aesthetics and chemical resistance.

• Single pack
• Self-levelling
• 5-30mm in one application
• Fast drying – apply moisture sensitive finishes after 24 hours
• Hard-wearing finish
• Foot traffic in 2-4 hours
• BS EN 13813 CT–C30–F7–RWA20
• Minimum thickness – 5mm, Maximum thickness – 30mm

Coverage:

3.2m² per 25kg @ 5mm
1.6m² per 25kg @ 10mm
0.53m² per 25kg @ 30mm

PRIMING

HEAVY TRAFFIC AREAS – Prime the substrate with one coat of Larprime EU with a sand scatter (2kg/m2 dry, clean sand 0.6-1.2mm applied into the wet primer with excess removed by vacuum when primer has cured).

LIGHT TRAFFIC AREAS – Substrate should be primed with Larsen Acrylic Primer diluted 1:1 with clean water. Porous substrates should be primed with Acrylic primer diluted 1:1 followed by Acrylic primer applied neat.

EXISTING LEVELLING COMPOUNDS (e.g. SLC1900 BASE) – should be primed with 1 coat of Acrylic primer diluted 1:1 followed by Acrylic primer applied neat. Acrylic primer should be allowed to dry before applying SLC 2000. If Acrylic primer has been left for more than 48 hours, a fresh application is required.

RESTRICTIONS 

SLC 2000 Industrial should not be applied to flexible surfaces. Room and substrate temperatures should be above 5°C during application. All work should be carried out to current best practice, trade body advice and BS8204. SLC2000 Industrial is suitable for use over underfloor heating systems. Room and substrate temperatures should be above 5°C during application. Drying times are dependent on screed thickness and site conditions. Always test moisture contents before laying impervious floor coverings. Protect surface from draughts, strong direct sunlight and following trades until covered.